x x e e o o n n 1 1 p p o o w w e e r r p p u u r r e e w w h h i i t t e e l l e e d d OSW4XME1E1E ver c.0 features outline dimension highest luminous flux super energy efficiency long lifetime operation built-in zener diode for esd protection superior uv resistance applications read lights (car, bus, aircraft) portable (flashlight, bicycle) bollards / security / garden traffic signaling / beacons in door / out door commercial lights automotive ext unit:mm tolerance:0.30mm esd protection diode anode cathode 3.6 backview absolute maximum rating (ta=25) directivity item symbol value unit dc forward current i f 400 ma pulse forward current* i fp 500 ma reverse voltage v r 5 v power dissipation p d 1600 mw operating temperature topr -30 ~ +85 storage temperature tstg -40~ +100 lead soldering temperature tsol 260 /5sec - *pulse width max.10ms duty ratio max 1/10 0 0 electrical -optical charac teristics (ta=25) forward operating current (dc) item symbol condition min. typ. max. unit dc forward voltage v f i f =350ma 3.0 3.3 4.0 v dc reverse current i r v r =5v - - 10 a luminous flux v i f =350ma 90 100 - lm color temperature cct i f =350ma - 6500 - k x i f =350ma - 0.31 - - chromaticity coordinates* y i f =350ma - 0.33 - - 50% power angle 2 1/2 i f =350ma - 140 - deg 400 350 300 250 0 50 100 150 200 0 25 50 75 125 ambient temperature, t a () , () 100 r j-a =60 /w r j-a =50 /w r j-a =40 /w r j-a =30 /w note: don?t drive at rated current more than 5s without heat sink for xeon 1 emitter series. led & application technologies http://www.optosupply.com ver c.0 1/2
http://www.optosupply.com ver c.0 2/2 x x e e o o n n 1 1 p p o o w w e e r r p p u u r r e e w w h h i i t t e e l l e e d d OSW4XME1E1E ver c.0 handling of silicone lens leds notes for handling of silicone lens leds please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. the leds should only be picked up by making contact with the sides of the led body. avoid touching the silicone lens especially by sharp tools such as tweezers. avoid leaving fingerprints on the silicone lens. please store the leds away from dusty areas or seal the product against dust. when populating boards in smt production, there are basica lly no restrictions regarding the form of the pick and place nozzle, except that mechan ical pressure on the silicone lens must be prevented. please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) led & application technologies
|
